1)	Start by inserting one cable end through a tag corner and laying the cable into the open side of the nearest Smart/Crimp. Shorten the loop as desired. Close the crimp with three progressive squeezes with the terminal pliers.
	2)	Bend crimp around so that it joins together with wire.
	3)	Loop wire into crimp.
	4)	Use crimper to seal. At the installation site, thread the loose end of the cable (along with one Smart/Crimp) through or around the device to be tagged.
	5)	Insert the cable end into the other corner of the tag, set the loop size, hang height of the tag and crimp in place.
	6)	Finally, bring the cables together with the last Smart/Crimp , balance the tag to level and adjust the crimp up to desired snugness of the "bowtie", and crimp. If desired, cut off excess cable beyond the last tag crimp.